Display Functions - Eaton Tripp Lite Series SmartPro Series Advanced User's Manual

Display Functions

4 4 . . 3 3 D D i i s s p p l l a a y y F F u u n n c c t t i i o o n n s s
Press the Enter ( ) button to activate the menu options. Use the two middle buttons (
the menu structure. Press the Enter (
to the previous menu.
Table 15. Menu Map for Display Functions
Main menu
CONTROL
LOCAL SETTING
IN/OUT SETTING
ON/OFF SETTING
BATTERY SETTING
COM SETTING
18 Eaton Tripp Lite Series SmartPro User Guide 614-40194—Rev 03
) button to select an option. Press the (ESC) button to cancel or return
Submenu
BATTERY TEST
RESET FAULT ST
CLEAR EVENT LOG
RESET KWH USED
FACTORY SETT
LANGUAGE
AUDIBLE ALARM
OUTPUT VOLTAGE
INPUT THRESHOLD
SENSITIVITY
OVRLOAD PREALARM
COLD START
AUTO RESTART
AUTO START
SLEEP MODE
SITE WIRING FLT
AUTO BAT TEST
RESTART LEVEL
BAT LOW LEVEL
BAT LOW TIME
REMOTE ON/OFF
REMOTE PWR OFF
INPUT DB9-4
OUTPUT RELAY
OUTPUT DB9-1
Display information or Menu function
Starts a manual battery test(possible if load>10% and battery
>80%).
Reset fault state.
Clears the faults and events stored.
Reset the power used.
Restore factory settings.
Sets product general parameters, see
Sets input and output parameters, see
Select output voltage through this submenu.
Input threshold can be set to normal or extended through this
menu.
Sensitivity can be set to high or low through this menu.
Overload pre-alarm can be set through this menu.
Cold start can be enabled or disabled through this menu.
Auto restart can be enabled or disabled through this menu.
Auto start can be enabled or disabled through this menu.
Sleep mode can be enabled or disabled through this menu.
Site wiring fault can be enabled or disabled through this
menu.
Auto battery test period can be set through this menu.
Restart battery level can be set through this menu.
Battery low percentage can be set through this menu.
Battery low remaining time can be set through this menu.
Select input signal function for REMOTE ON/OFF.
Select input signal function for REMOTE PWR OFF.
Select input signal function for INPUT DB9-4.
Select output signal function for OUTPUT RELAY.
Select output signal function for OUTPUT DB9-1.
and ) to scroll through