Table of Contents
Advertisement
C C h h a a p p t t e e r r 5 5 O O p p e e r r a a t t i i o o n n
5 5 . . 1 1
S S t t a a r r t t - - u u p p a a n n d d n n o o r r m m a a l l o o p p e e r r a a t t i i o o n n
Check that the indications on the name plate located on the back of the UPS meets to the AC power source
and the true electrical consumption of the total load.
B B a a t t t t e e r r y y c c h h a a r r g g e e
The UPS charges the battery as soon as it is connected to the AC outlet, whether the ON/OFF button is
pressed or not. It is recommended that the UPS be permanently connected to the AC power supply to ensure
the best possible autonomy.
To start the UPS:
1.
Verify that the UPS power cord is plugged in.
2.
The UPS front panel display illuminates.
3.
Press the
4.
Check the UPS front panel display for active alarms or notices. Resolve any active alarms before
continuing; if the
from the front panel to view the active alarms. Correct the alarms and restart if necessary.
5.
Verify that the
are powered and protected. The UPS should be in Normal mode.
5 5 . . 2 2
S S t t a a r r t t i i n n g g t t h h e e U U P P S S o o n n b b a a t t t t e e r r y y
Before using this feature, the UPS must have been powered by utility power with output enabled at least once.
Battery start can be disabled. See the "Cold start" setting in .
To start the UPS on battery:
1.
When the UPS is disconnected from the AC power source, press the
The UPS transfers from Standby mode to Battery mode. The
The UPS supplies power to your equipment.
2.
Check the UPS front panel display for active alarms or notices besides the "Battery mode" and related
notifications that indicates missing utility power. Resolve any active alarms before continuing. See .
Check the UPS status from the front panel to view the active alarms. Correct the alarms and restart if
necessary.
5 5 . . 3 3
U U P P S S s s h h u u t t d d o o w w n n
To shut down the UPS:
Press the
The UPS starts to beep and shows a status of "SHUTTING DOWN...". The UPS then transfers to Standby mode.
button on the UPS front panel for at least two seconds.
indicator is on, do not proceed until all alarms are clear (see ). Check the UPS status
indicator illuminates solid, indicating that the UPS is operating normally and any loads
button on the front panel for three seconds.
Eaton Tripp Lite Series SmartPro User Guide 614-40194—Rev 03
button on the UPS front panel.
indicator illuminates solid.
21
Advertisement
Table of Contents
