After Operation - Exmark Ultravac Bagger 126-8680 Operator's Manual

Operation
B. Secure the bottom of the bracket to the caster
arm with a clevis pin and hairpin.
C. Tighten the knob on weight assembly until it
is clamped securely to the caster arm.
D. Install three 20 lb (9.1 kg) caster weights over
the weight assembly screw and stack them
securely onto the 45 lb (20.4 kg) caster weight.
Secure the rear of the weight assembly with a
3/8-16 inch nyloc nut.
E. Install 3/8-16 x 8 inch screw and washer
through the top of the front holes of the
weight assembly and secure with 3/8-16 inch
nyloc nut.
F. Repeat for the RH side.

After Operation

General Safety
• Park machine on level ground, disengage drives,
set parking brake, stop engine, remove key or
disconnect spark plug wire. Wait for all movement
to stop and allow the machine to cool before
adjusting, cleaning, repairing, or storing. Never
allow untrained personnel to service machine.
• Clean the machine as stated in the Maintenance
section.
• Frequently check for worn or deteriorating
components that could create a hazard. Tighten
loose hardware.
16