Table of Contents
Advertisement
EQ33-2 Installation and service
SimNet is a high-speed control and data network designed to integrate SimNet
products into a complete system. Ready-made cables with small plugs makes
it easy to run cables. Only 10 mm (3/8") holes are required through panels and
bulkheads. The SimNet accessory program contains the necessary items to
make a successful installation, see section 10.9 Specifications.
Plug and Play - once all products are connected and power is switched on, the
entire network system will be set up automatically and will ensure optimum
performance.
SimNet interface connection for EQ33-2 is made directly to the receptacle
marked NET on the rear of the cabinet. Use a Tee Joiner to make a drop
connection from the SimNet system to the NET receptacle.
SimNet power and termination
The following simple rules should be observed when installing SimNet:
• SimNet must be powered with 12 VDC and connected to the battery via
circuit breaker and 5 amp fuse.
• Do not connect the SimNet power cable to the same terminals as the
Autopilot Computer, Radar, thruster or other high current products.
• SimNet should normally be terminated in each end, starting with the power
cable with termination in one end and termination plug or wind transducer
(with termination) in the other end.
EQ33-2
Tee Joiner
NET
SimNet
Chapter 10-7
Advertisement
Table of Contents
