Initial Start-Up - Simrad EQ33-2 Instruction Manual

Chapter 2-6

2.5 Initial start-up

When starting up for the very first time, the first time after loading
a new software or after a master reset: Make sure that all hardware
installation and electrical connections are completed in accordance
to the installation instructions.
Press and hold the [PWR] key until you have a picture on the screen
PWR
The system will perform a software update and check for com-
munication activity. When finished, a new start-up window will be
presented on the screen:
After making sure that all connected products are turned ON:
Press [ENT] to start automatic input source setup, - if a new product
ENT
is connected later on, refer to section 8.4 Interface setup.
New window: Automatic input source setup listing Data type, Group
and Source of connected units.
Press [ENT] to continue
ENT
ENT
Press the [ENT] key when the legend 'System Ready' appears on the
screen, - go to [MENU], [6], [3] if you wish to make adjustments to
the interface setup.
Heading is only available if a compass was detected at start-up.
Automatic input source setup
Interface has not been set up!
To start automatic input
source setup, make sure that
all connected products are
turned ON, and press ENT.
EQ33-2 Fundamentals & initial start-up
Start
∆
ENT