Simrad EQ33-2 Instruction Manual page 56

Chapter 8-10
GAIN+
Go to Water interface - step back with [GAIN-]
◄
GAIN-
Water depth input:
Group selection:
Source (multiple available):
Water temperature input:
Group selection:
Source (one available):
Water temperature offset:
Water speed input:
Group selection:
Source (one available):
LOG speed cal.:
NMEA0183 output:
Water temperature:
Water speed and heading:
Depth:
Depth below keel:
Depth below surface:
Depth below transducer:
MENU
Input:
selected for depth.
Water temperature offset - a figure can be keyed in to compensate
for differencies in temperature sensor.
LOG speed calibration - the unit is preset to receive 19000 pulses
per nautical mile from the log transducer (paddle wheel). However
the figure might have to be changed to compensate for various trans-
ducers and actual water flow passing the transducer. The correct
pulse rate is calculated by:
19000 x indicated speed (e.g. 4kn) = 15.200 pulses/nm
NMEA0183 output - see also section 8.4.1 Description of sentences.
Navigation
Simrad EQ33
Airmar EQS
Airmar EQS
Exit
INTERNAL ONLY
actual speed (GPS) (e.g. 5kn)
Compass
Water
INTERNAL ONLY
,Sn:00C192
,Sn:000000
,Sn:000000
019000 PULSES/nm
MTW
VHW
DPT
DBK
DBS
DBT
Accepter
- indicates that no external source can be
EQ33-2 SETUP menu
GAIN+
►
∆
SIMRAD
SIMRAD
+0.0°C
SIMRAD
ON
ON
ON
OFF
OFF
OFF
ENT