Table of Contents
Advertisement
Introduction - Section 10
Page 10-8
This manual is written for use by the operator and/or the service technician. It is designed to help these persons
learn how to operate the truck and its systems in order to keep it operating safely and efficiently. All operators and
maintenance personnel must read and understand the materials in this manual before operating the truck or per-
forming maintenance and/or operational checks on the truck. All safety notices, warnings, and cautions should be
understood and followed when operating or performing repairs on the truck.
The front cover of this manual includes a form number. This form number should be referenced when ordering
additional copies of this manual, or for any other correspondence regarding the coverage in this manual.
Direct all inquiries to:
Komatsu America Corp.
Datakom, Peoria Technical Publications
P.O. Box 240
Peoria, IL 61650-0240
United States of America
Fax (309) 672-7072
This first section is an introduction to the manual and contains the table of contents to locate specific areas of inter-
est.
When searching for a specific area of interest, go first to the table of contents to locate the section in which the sub-
ject might generally be included. Then, go to that section of the table of contents to find a subject description that
most closely describes the specific area of interest to find a page number and go to that page. Section numbers
and page numbers are located at the top, outside corner of the page.
At the top, inside corner of the page is a document (module) number. If there is ever a question regarding the infor-
mation in a particular section, refer to the document (module) number, the manual form number, and use the
address shown above to correspond. If there is a date (month/year) behind the document (module) number, that
indicates the latest revision date of that page.
The illustrations used in this manual are TYPICAL of the component shown and may not be an exact reproduction
of what is found on the truck.
This manual shows dimensioning of U.S. standard and metric (SI) units throughout. All references to "right", "left",
"front", or "rear" are made with respect to the operator's normal seated position, unless specifically stated other-
wise.
When assembly instructions are provided without references to torque values, standard torque values should be
assumed. Standard torque requirements are shown in torque charts on the following pages of this section, and in
the General Information section of the truck shop manual. Individual torques when provided in the text are in bold
face type, such as 135 N.m (100 ft lbs). All torque specifications have ±10% tolerance unless otherwise specified.
ABOUT THIS MANUAL
OM1099
Advertisement
Table of Contents
