Table of Contents
Advertisement
The radio tries to establish connection with the device once paired.
NOTE: If the connection fails within 6 seconds, you hear a decremental-pitched tone to indicate
that the device is unpaired. The display shows <Device Type> UNPAIRED. Repeat this step
to re-initiate the pairing process.
If the connection is successful, you hear an incremental-pitched tone. The display shows <Device
Type> CONNCTED and the Bluetooth icon turns from
If the radio has the pairing record of the device and the connection fails, you hear a short, low-pitched
tone. The display shows <Device Type> CON FAIL.
7.19.2
Pairing with LEX Handheld
Prerequisites: Ensure that Bluetooth feature of your radio is on and the Bluetooth tones are enabled.
Procedure:
1 Turn on the handheld and activate the Bluetooth feature.
2 Place the handheld close to the radio aligning the Bluetooth Pairing Location on the handheld
with the Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an incremental-pitched tone from the radio. The
radio begins to connect to the handheld. If the connecting process is successful, you hear an
incremental-pitched tone. The display shows <Device Friendly Name> connected, and
the Bluetooth icon turns from
If unsuccessful, one of the following scenarios occur:
•
You hear a short, low-pitched tone and the display shows Bluetooth pairing failed (if
pairing fails).
•
You hear a decremental-pitched tone and the display shows <Device Friendly Name>
unpaired (if the connection fails within 6 seconds).
•
You hear a short, low-pitched tone and the display shows <Device Friendly Name>
connect failed (if the radio has the pairing record of the handheld and the connection
fails).
Repeat this step to re-initiate the pairing process.
NOTE: To unpair the handheld after a successful connection, follow the steps in
and Clearing the Bluetooth Device
7.19.3
Responder Alert Sensors
Responder alert sensors allow the radio to send an over-the-air (OTA) notification when the radio
receives the holster, weapon fired, and vest pierced sensor events.
To enable the feature, ensure that the GPS, Enhanced Data, and Bluetooth feature of your radio is
turned on and the radio supports Bluetooth Low Energy (BTLE).
You can disable the feature temporarily or permanently. This feature allows you to prevent one or all
events from being reported OTA.
to
.
to
.
Information.
68012001081-JW
Chapter 7 : Advanced Features
Viewing
67
Advertisement
Table of Contents
