Table of Contents
Advertisement
MN006727A01-AA
Advanced Features
If successful, the display shows ALL CLR.
If unsuccessful, the radio sounds a short, low-pitched tone.The display shows CLR FAIL.
Postrequisites:
NOTICE: If Re-Pair Timer is set to infinite and you clear keys on the radio, you must clear keys
on all previously paired devices as well. (Please see your accessories manual for further
details.)
6.14.9
Pairing with LEX Handheld
Prerequisites: Ensure that Bluetooth feature of your radio is on and the Bluetooth tones are enabled.
Procedure:
1 Turn on the handheld and activate the Bluetooth feature.
2 Place the handheld close to the radio aligning the Bluetooth Pairing Location on the handheld
with the Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an incremental-pitched tone from the radio. The
radio begins to connect to the handheld. If the connecting process is successful, you hear an
incremental-pitched tone. The display shows <Device Friendly Name> connected, and
the Bluetooth icon turns from
If unsuccessful, one of the following scenarios occur:
•
You hear a short, low-pitched tone and the display shows Bluetooth pairing failed (if
pairing fails).
•
You hear a decremental-pitched tone and the display shows <Device Friendly Name>
unpaired (if the connection fails within 6 seconds).
•
You hear a short, low-pitched tone and the display shows <Device Friendly Name>
connect failed (if the radio has the pairing record of the handheld and the connection
fails).
Repeat this step to re-initiate the pairing process.
NOTICE: To unpair the handheld after a successful connection, follow the steps in
Viewing and Clearing the Bluetooth Device
6.14.10
Responder Alert Sensors
Responder alert sensors allow the radio to send an over-the-air (OTA) notification when the radio
receives the holster, weapon fired, and vest pierced sensor events.
To enable the feature, ensure that the GPS, Enhanced Data, and Bluetooth feature of your radio is on
and the radio supports Bluetooth Low Energy (BTLE).
You can disable the feature temporarily or permanently. This feature allows you to prevent one or all
events from being reported OTA.
This feature is enabled through Customer Programming Software (CPS) configuration. Contact your
system administrator for more information.
66
to
.
Information.
Advertisement
Table of Contents
