Installing The High-Pressure Pump; Installing An Inline Filter; Installing The Pulsation Absorber; Injection Valve - Metrohm 930 Compact IC Flex Manual - Short Instructions

5.8 Installing the high-pressure pump

5.8 Installing the high-pressure pump
5.9

Installing an inline filter

5.10

Installing the pulsation absorber

5.11

Injection valve

5.12

Installing the conductivity detector

22
￭￭￭￭￭￭￭￭
The high-pressure pump is completely connected. No installation work is
required.
The inline filter is completely connected. No installation work is required.
The pulsation absorber is installed between the high-pressure pump and
the injection valve. It protects the separation column from damage caused
by pressure fluctuations, e.g. when the injection valve is switched, and
reduces interfering pulsations during highly sensitive measurements.
The pulsation absorber is completely connected. No installation work is
required.
The injection valve is completely connected. No installation work is
required.
The 930 Compact IC Flex provides enough space for one detector and
additional accessories in the detector chamber. The detector is available as
a separate device and is supplied with a separate manual.
NOTICE
For ideal performance, Metrohm recommends using the 930 Compact
IC Flex Oven/Deg/MB in combination with the IC Conductivity Detector
MB (2.850.9020).
Placing the detector in the instrument
Follow the instructions in the chapter Inserting the detector in the manual
for the detector.
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
930 Compact IC Flex Oven/Deg/MB (2.930.2180)