To Migrate The System Data For The System Speed Dialing (300 Memories); For Non-Tenant-Basis Operation - NEC UNIVERGE SV9300 Migration Manual

To Migrate the System Data for the System
Speed Dialing (300 Memories)
The system data for the 'System Speed Dialing (300 memories)' is not migrated by the System Data
Conversion Tool. To migrate the system data for the 'System Speed Dialing (300 memories)', follow the
procedure below.
Perform this migration work in the migration procedure steps below. (
Assign SV8300 system data that is not migrated to SV9300 during system data conversion.
After completing the system data settings, back up the system data (CMEC Y=6>0: 0).
[Required Time: About 5 minutes]

For Non-Tenant-Basis Operation

Set 1000-Slot Memory Block to which the System Speed Dialing (300 memories) is
allocated. [Required Time: About 10 minutes]
- Usage of Memory for Speed Dialing: CM73 Y=0>00-99: 0 (System Speed Dialing [for
- Memory allocation for System Speed Dialing: CM73 Y=2>00-63
Open the file for migrating the system data for System Speed Dialing (300 memories)
(SystemSpeedDial(300).xls), input a 1000-Slot Memory Block No. and a 10-Slot Memory
Start Block No., and then save the file. [Required Time: About 3 minutes]
NOTE: The file for migrating the system data for System Speed Dialing (300 memories)
(SystemSpeedDial(300).xls) is generated at the same time when the whole system
data file (.syd) saved by the SV8300 PCPro is converted into Scripts (including a
Scinario) by using SV9300 System Data Conversion Tool.
On the [Script] screen of the SV9300 PCPro, run the file for migrating the system data for
System Speed Dialing (300 memories) (SystemSpeedDial(300).xls) saved in the step
above. [Required Time: About 3 minutes]
CHAPTER 2 MIGRATION PROCEDURE
Start
individual tenants])
End
- 19 -
Page 10, Page 14)