Husqvarna Automower 305 Operator's Manual page 40

Message
Charging current too
high
Trapped
Mower tilted
Upside down
Needs manual charg-
ing
Next start hh:mm
Today's mowing
completed
Lifted
Electronic problem
Loop sensor prob-
lem, front/rear
Tilt sensor problem
Temporary problem
Invalid sub-device
combination
Temporary battery
problem
Safety function faulty
Connectivity problem
Connectivity settings
restored
Poor signal quality
40 - Troubleshooting
Cause
Wrong or faulty power supply unit.
The product is stuck in a small area behind a
number of obstacles.
The product is tilted more than the maximum
angle.
The product is leaning too much or has
turned over.
The product is set to the
erating mode.
The schedule setting prevents the product
from operating.
The product has reached its maximum cut-
ting time for the day.
The clock or date in the product is not cor-
rect.
The product has reached its maximum cut-
ting time for the day.
The lift sensor has been activated as the
product has been lifted.
Temporary electronic or firmware related is-
sue in the product.
Potential problem on the connectivity circuit
board in the product.
The connectivity settings was restored due to
a fault.
The connectivity circuit board in the product
is assembled upside down, or the product
itself is tilted or upside down.
Action
Restart the product. If the problem stays
speak to your authorized service technician.
Check if there are any obstacles which make
it hard for the product to move on from this
location. Remove the obstacles or create
an island around the obstacles. Refer to
make an island on page 16 .
Move the product to a flat area.
Turn the product the right way up.
Secondary area op-
Put the product in the charging station.
Change the schedule settings. Refer to
Schedule on page 22 .
This behavior is normal and no action is re-
quired.
Set the time. Refer to
on page 29 .
This behavior is normal and no action is re-
quired. Refer to
essary operating time on page 23 .
Check that the product body can move freely
around its chassis. Remove or create an is-
land around objects that can cause the chas-
sis to be lifted. If the problem stays speak to
your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Check and change the settings if needed.
Make sure that the product is not upside
down or tilted. If the problem stays speak to
your authorized service technician.
To set the time & date
Make an estimate of the nec-
1462 - 008 - 20.02.2023
To