Husqvarna Automower 305 Operator's Manual page 25

4.2.6.1 To set the Weather Timer
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 22 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Weather Timer .
3. Push the OK button to select the
4. Push the BACK button.
4.2.6.2 To set the Weather Timer frequency
Set how frequently the product cuts the grass when the
Weather Timer is in use. There are 3 frequency levels:
Low, Mid and High . The higher the frequency, the more
sensitive the product is to the grass growth. That is, if
the grass growth is high then the product is allowed to
work longer.
Note:
If the mowing results are not optimal when
Weather Timer , the schedule settings may need
using
adjusting. Do not restrict the schedule more than
necessary. Also, check that the blade disc is clean and
that the blades are in good condition.
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 22 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Cutting time .
3. Use the arrow buttons to select
frequency.
4. Push the BACK button.
4.2.7 Installation
In the Installation menu it is possible to adapt the
settings of the product for best mowing result.
4.2.7.1 Lawn Coverage and Systematic Passage
Mowing
If the work area includes remote parts that are
connected with narrow passages, the
Systematic Passage Mowing function are useful to
and
be able to maintain a well-cut lawn in all parts of the
Lawn Coverage function is used to guide
yard. The
the product to remote parts of the work area. The
Systematic Passage Mowing function is used for narrow
passage mowing. A guide wire must be installed to use
these functions. You can set a maximum of 3 remote
areas.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a certain
distance and starts to mow the lawn.
1462 - 008 - 20.02.2023
Weather Timer > Use
Weather Timer .
Weather Timer
Low, Mid or High
Lawn Coverage
Systematic Passage Mowing function is suitable
The
to mow narrow passages of 60 cm - 1.5 m / 23 in. -
4.9 ft. width. The product moves in a pattern to cover
the passage width. The product starts the
Passage Mowing at the set distance from the charging
station. When the product reaches the end of the narrow
passage, the product continues and cuts the lawn as
normal.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
To set the Lawn Coverage function
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 22 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Coverage > Area 1-3 .
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging station
to the start of the area. Measure along the guide
To measure the distance from the
wire. Refer to
charging station on page 26 .
6. Push the arrow buttons to select the distance,
measured in m.
7. Push the OK button.
8. Use the arrow buttons to select the percentage of
the cutting time the product must cut the area. The
percentage is equal to the percentage of the area
in relation to the complete work area.
a) Measure the area.
b) Divide the measured area with the total work
area.
c) Convert the result to percentage.
Systematic
C
B
Settings > Lawn
Product settings - 25