Husqvarna Automower 305 Operator's Manual page 39

Message
Wrong PIN code
No drive
Slipped
Collision sensor
problem, front/rear
Alarm! Mower switch-
ed off
Alarm! Mower stop-
ped
Alarm! Mower lifted
Alarm! Mower tilted
Alarm! Mower was
moved
Charging station
blocked
Stuck in charging sta-
tion
Charging system
problem
1462 - 008 - 20.02.2023
Cause
Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for a period of time.
The product has got caught in something and
has been slipping.
The work area includes a steep slope.
The guide wire is not laid diagonally in the
slope.
The drive wheels on the product are blocked. Free the product and correct the cause of
The alarm is activated because the product
had been switched off.
The alarm is activated because the product
has been stopped.
The alarm is activated because the product
has been lifted.
The alarm is activated because the product
has been tilted.
The alarm is activated because the product
has been lifted.
The contact between the charging plates on
the product on the and contact plates on
the charging station may be poor and the
product has made a number of attempts to
charge.
An object is in the way of the product that
prevents it to enter the charging station.
The charging station is tilted or bent.
The guide wire is not installed correctly.
There is an object in the way of the product
preventing it from leaving the charging sta-
tion.
There is corrosion or dirt on the charging
plates and contact plates.
Temporary electronic or firmware problem in
the product.
Action
Enter the correct PIN code. If the PIN code is
incorrect, use the link in the app to send the
PIN code to your registered e-mail address.
If you have not registered the e-mail address,
contact your local Husqvarna representative.
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass,
wait until the lawn has dried before using the
product.
Steep slopes should be isolated. Refer to
put the boundary wire in a slope on page 15 .
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
a secondary area on page 16 .
problem. If the problem stays, speak to your
authorized service technichian.
Adjust the security level in the
To set the security level on
menu. Refer to
page 24 .
Put the product in the charging station and
check that the charging plates and contact
plates make good contact.
Remove the object.
Put the baseplate on level ground.
Check if the guide wire is installed accord-
ing to the instructions. Refer to
guide wire on page 19 .
Remove the object.
Restart the product. Clean the charging
plates on the product and the contact plates
on the charging station.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
To
To make
Security
To install the
Troubleshooting - 39