Husqvarna Automower 305 Operator's Manual page 23

Note:
The lawn should not be cut too often to obtain
the best result. If the product is allowed to operate too
much, the lawn may appear flattened. The product is
also subjected to unnecessary wear.
4.2.3.1 To set the schedule
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 22 .
2. Use the arrow buttons and the OK button to move
through the menu structure
3. Use the arrow buttons and the OK button to select
the day.
4. Use the right arrow button to select the period.
5. Push the OK button.
6. Calculate the suitable operating hours. Refer to
Make an estimate of the necessary operating time
on page 23 .
7. Enter the time with the number buttons. The
product can cut the grass 1 or 2 periods each day.
8. If the product must not cut grass on a specified
day, unselect the box adjacent to the 2 time
periods.
4.2.3.2 Make an estimate of the necessary operating
time
If the work area is less than maximum product capacity,
the schedule must be set to decrease the wear on the
lawn and the product. The product has a maximum
cutting time each day. You can set the operating time of
the product in the schedule. The operating time includes
cutting, searching and charging. The operating time can
be different because of many reasons, for example the
layout of the work area, the grass growth and age of the
battery. When the product has operated to the maximum
cutting time in a day, the message
complete is shown in the display of the app.
The recommended operating times for some work area
examples are shown in the table below. If the result is
not satisfactory, increase the operating time.
2
Area, m
300
600
4.2.3.3 To copy the schedule setting
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 22 .
1462 - 008 - 20.02.2023
Schedule > Overview .
Today's mowing
Recommended operating
time, h
4-5
9-10
2. Use the arrow buttons and the OK button to move
through the menu structure
Copy .
3. Use the arrow buttons and the OK button to copy
the schedule setting. You can copy the schedule
settings day to day or for the full week.
4.2.3.4 To reset the schedule setting
You can remove all schedule settings and use the
factory setting.
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 22 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Reset .
a) Push the arrow buttons to select
day to only reset the current day to factory
settings.
b) Push the arrow buttons to select
reset all schedule settings to factory settings.
3. Push the OK button.
4.2.4 Security level
There are 3 security levels for the product.
Function Low
Alarm
PIN-code
Time lock
Alarm - An alarm goes off if the PIN-code is not
•
entered within 10 seconds after the STOP button is
pushed. The alarm also goes off when the product
is lifted. The alarm stops when the PIN-code is
entered.
• PIN-code - The correct PIN-code must be entered
to get access to the Menu structure of the product.
If the incorrect PIN-code is entered 5 times, the
product is locked for a time. The lock is extended
for each new incorrect try.
Time lock - The product locks if the PIN-code has
•
not been entered in 30 days. Enter the PIN-code to
get access to the product.
Schedule > Overview >
Schedule > Overview >
Current
All week to
Medium
X
X X
Product settings - 23
High
X
X
X