Power Fist 9095738 Manual page 14

9095738 20V Cordless Brushless Dry Cut Metal Saw, Tool Only
3. Holding the spindle lock lever in place,
use the hex wrench (Fig. 11-1) to
remove the hexagonal bolt (Fig. 11-2).
4. Remove the out flange (Fig. 11-3).
5. Raise the removable guard (#66) to its
highest position.
6. Remove the old blade.
7. Insert the new blade, spinning it by
hand to ensure proper rotational
direction, no defects and that it fits (Fig. 11-4).
8. If the inner flange (Fig. 11-5) was removed, be sure to install it on the
spindle (Fig. 11-6).
9. Place the outer flange and hexagonal bolt through the threaded arbor
hole and tighten with your fingers.
10. Push in the spindle lock lever while tightening the hex bolt.
TRANSPORTATION
1. Fold the tool arm (#29) to the base plate (Fig. 12).
2. Push the lock pin (#31) to lock.
3. Transport safely to desired location.
4. Unlock the tool and raise the arm.
5. Depress the arm slightly and pull the lock pin
out. This will allow the arm to pivot upward.
CLEANING
Clean the tool using only soft brush or rag with mild
detergent or soap. Do not use caustic agents to
clean this tool.
LUBRICATION
Inspect and lubricate the tool when required. Only use light oil to lubricate
the tool. Other lubricants may not be suitable and could damage the tool or
cause a malfunction during use.
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
14 For technical questions call 1-800-665-8685
V1.0
Fig. 11
Fig. 12