Group 20
Step 2: Visual Inspection (System Checks)
Action:
Check the fuel lines for damage, leakage, or restrictions. Also check that connections
and seals are correctly installed.
Check that EECU cable harness, including connectors and pins, is fault free and correctly
connected.
"Step 3: VCADS Pro Tests" page 15
Step 3: VCADS Pro Tests
Action:
Check sensor values.
Check fuel supply pressure at low and high engine speeds.
Check Parameters
Check cylinder compression.
Check camshaft and flywheel signals at cranking speed.
"Step 4: Component and Function Checks" page 16
T2020217
C2002640
D
Refer to:
"Engine Starts But Will Not Continue to Run" page 5
Refer to:
Sensor Values, Engine Not Running
Fuel Supply Pressure, Check
Parameter Programming
Cylinder Compression, Test
Flywheel and Camshaft Signal, Test
"Engine Starts But Will Not Continue to Run" page 5
15