Table of Contents
Advertisement
1. Left foot shield
7.
Mount the left foot shield to the top and side of
the mower deck with 3 carriage bolts (5/16 x 3/4
inch) and 3 nuts (5/16 inch) as shown in
5.
8.
Install the blades, anti-scalp cups, and blade
bolts
(Figure
6).
Important:
The curved part of the blade
must point toward the top of the cutting unit
to ensure proper cutting.
1. Blade bolt
9.
Tighten the blade bolts to 115 to 149 N-m (85
to 110 ft-lb).
10.
Rotate the blades to ensure that there is no
interference
11.
Tighten all fasteners.
12.
Affix an identification decal to the top of the
mower deck near the serial plate
Note:
Make sure that the mounting surface is
clean.
Figure 5
2. Right foot shield
Figure 6
2. Anti-scalp cup
(Figure
g029609
Figure
1. Identification decal
g004741
7).
5
Figure 7
g014978
Advertisement
Table of Contents
