Table of Contents
Advertisement
Figure 11
1. Support strap
6.
Tighten all fasteners.
7.
Mount the right foot shield to the top and side
of the mower deck with 4 carriage bolts (5/16 x
3/4 inch) carriage bolts and 4 nuts (5/16 inch)
as shown in
Figure
Figure 12
1. Right foot shield
8.
Mount the left foot shield and a deflector to the
top and side of the mower deck with 2 carriage
bolts (5/16 x 7/8 inch), 2 carriage bolts (5/16 x
3/4 inch), 2 washers, and 4 nuts (5/16 inch) as
shown in
Figure
13.
12.
g029613
1. Nut
2. Left foot shield
3. Deflector
9.
Install the blades, anti-scalp cups, and blade
bolts
(Figure
Important:
must point toward the top of the cutting unit
to ensure proper cutting.
g029621
1. Blade bolt
10.
Tighten the blade bolts to 115 to 149 N-m (85
to 110 ft-lb).
11.
Rotate the blades to make sure there is no
interference.
12.
Tighten all fasteners.
13.
Affix an identification decal to the top of the
mower deck near the serial plate
Note:
Ensure that the mounting surface is
clean.
7
Figure 13
4. Washer
5. Capscrew
6. Carriage bolt
14).
The curved part of the blade
Figure 14
2. Anti-scalp cup
(Figure
g029614
g004741
15).
Advertisement
Table of Contents
