Assembly
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Decal
Operator's Manual
Parts Catalog
Registration Card
Inspection
After the cutting unit is unboxed, inspect the
following:
1. Check each end of the reel for grease. Grease should
be visibly evident in the reel bearings and internal
splines of reel shaft.
2. Ensure that all nuts and bolts are securely fastened.
3. Make sure carrier frame suspension operates freely and
does not bind when moved back and forth.
Adjusting Front Shield
Adjust front shield for desired grass clippings
dispersion.
1. Position cutting unit on a flat level surface.
2. Loosen flange head capscrew securing shield to right
side plate. Move shield to desired angle and tighten
screw (Fig. 2).
QTY.
1
Apply over existing decal for CE
1
Read before operating machine.
1
Use for ordering replacement parts.
1
Fill out and return to Toro.
2
3
4
1. Front grass shield
2. Front capscrew
Adjusting Rear Shield
Under most conditions, best dispersion is attained
when rear shield is closed (front discharge). When
conditions are heavy or wet, rear shield may be
opened.
1. To open rear shield (Fig. 2), loosen flange head
capscrew securing shield to right side plate, rotate
shield to open position and tighten capscrew.
5
USE
1
Figure 2
3. Rear grass shield
4. Rear capscrew