Installing A Pcie Network Adapter - H3C SecCenter CSAP-SA Installation Manual

Figure 21 Installing a power supply
3. Connect the power cord. For more information, see
Verifying the installation
Use one of the following methods to verify that the power supply is installed correctly:
•
Observe the power supply LED to verify that the power supply is operating correctly. For more
information about the power supply LED, see LEDs in "Rear panel."
•
Log in to HDM to verify that the power supply is operating correctly.

Installing a PCIe network adapter

Procedure
1. Power off the server. For more information, see
2. Remove the server from the rack. For more information, see
3. Remove the access panel. For more information, see
4. Remove the riser card. Lift the riser card out of the chassis.
Figure 22 Removing the riser card
5. Install the PCIe network adapter to the riser card:
a. Remove the PCIe module blank. Remove the screw that secures the blank and then pull the
blank out of the slot.
"Connecting the power
"Powering off the
"Removing the server from a
"Removing the access
3
cord."
server."
panel."
rack."