Connecting A Usb Device - H3C SecCenter CSAP-SA Installation Manual

Connecting a USB device

About this task
Perform this task before you install the operating system of the server or transmit data through a
USB device.
The server provides a maximum of five USB connectors.
•
Three USB connectors on the front and rear panels.
•
Two internal USB connectors for connecting USB devices that are not designed to be installed
and removed very often.
Guidelines
Before connecting a USB device, make sure the USB device can operate correctly and then copy
data to the USB device.
USB devices are hot swappable.
As a best practice for compatibility, purchase H3C-certified USB devices.
Procedure
1. (Optional.) Remove the access panel if you need to connect the USB device to an internal USB
connector. For information about how to remove the access panel, see
panel."
2. Connect the USB device to the USB connector, as shown in
Figure 7 Connecting a USB device to an internal USB connector
3. (Optional.) Install the access panel. For information about how to install the access panel, see
"Installing the access
4. Verify that the server can identify the USB device.
If the server fails to identify the USB device, download and install the driver of the USB device.
If the server still fails to identify the USB device after the driver is installed, replace the USB
device.
panel."
5
"Removing the access
Figure 7.