Table of Contents
Advertisement
The firewall does not come with any drives and cannot recognize drives from other vendors.
Purchase drives from H3C as needed.
To install a drive:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel over the drive slot.
3.
Press the red button on the drive panel to release the locking lever.
4.
Hold the locking lever, slide the drive into the slot along the guide rails, and then close the
locking lever.
Figure2-10 Installing the drive
1
Connecting Ethernet cables
Connecting a copper Ethernet port
You can use either a straight-through or a cross-over network cable to connect a copper Ethernet
port. For more information about Ethernet twisted pair cables, see "Ethernet twisted pair cable."
To connect a copper Ethernet port:
1.
Connect one end of the Ethernet cable to the copper Ethernet port of the firewall, and the other
end to the Ethernet port of the peer device.
2.
Examine whether the LEDs of the Ethernet port are normal. For more information about LEDs,
see "Appendix B LEDs."
After connecting the firewall to the network, you can use the
examine network connectivity. For more information, see the related command reference.
Connecting a fiber port
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the switch is operating.
2
3
2-9
or
command to
ping
tracert
Advertisement
Table of Contents
