Assa Abloy ALARM CONTROLS Magnalock 1200DE Delayed Egress Installation & Operating Instructions page 4

General DIP Switch Settings
Bypass
Nuisance Irrevocable
Code (Release)
Delay Alarm
Delay
SW1 SW2 SW3 SW4
Sec Sec
Standard
for all
other
Off Off Off
0
regions
Off 15
On Off 1 On
(Factory
Setting Off On 2 Off
On 30
Bolded)
On On 3 On
SW1 SW2 Sec SW3 Sec SW4
Off Off 1 Off
Off 15
Chicago
On Off 1 On
Off On 1 Off
On 15
On On 1 On
SW1 SW2 SW3 SW4
Sec Sec
Off Off 0 Off
California
Off 15
15
On Off 1 On
Seconds
Off On 2 Off
On 15
On On 3 On
SW1 SW2 Sec SW3 Sec SW4
Off Off 0 Off
California
Off 30
30
On Off 1 On
Seconds
Off On 2 Off
On 30
On On 3 On
*May not be applicable to specific Chicago and California variants. Please consult local AHJ to ensure code requirements are met.
6 of 8
Remote
Power-Up
Exit Cycle Alarm Type
lock/unlock
Trigger
SW5 SW6 SW7 SW8
Sec Status Status
Off
0
Disables
Off Unlock Off Off
External
Off 5
On 10
Enables
On Lock On On
External
On 30
SW5 Sec SW6 Status SW7 Status SW8
Off 0
Disables
Off Unlock Off Off
External
Off 0
On 0
Enables
On Unlock On On
External
On 0
SW5 SW6 SW7 SW8
Sec Status Status
Off 0
Disables
Off Unlock Off Off
External
Off 0
On 0
Enables
On Unlock On On
External
On 0
SW5 Sec SW6 Status SW7 Status SW8
Off 0
Disables
Off Unlock Off Off
External
Off 0
On 0
Enables
On Unlock On On
External
On 0
Model Confirmation Display Codes
If auto relock is disabled, the 1200DE will show one of the following codes upon reset:
• -0 Standard 1200DE variant
Auto or
• -1 1200DE Chicago variant
Manual
Relock
• -2 1200DE California 15 second variant
• -3 1200DE California 30 second variant
SW9
Status Status
Behavior of Delayed Egress
with Regional Settings
Voice Off Manual
California
Tone On Auto
Upon power up, lock goes into an alarm state and requires a manual reset. Nuisance delay
is settable to 0, 1, 2 or 3 seconds and the exit delay is fixed at 15 or 30 seconds. A manual
Status SW9 Status
reset is required after a delayed egress event.
Chicago
Voice Off Manual
Upon power up, lock goes into an alarm state and requires a manual reset. Nuisance delay is
fixed at 1 second, the exit delay is fixed at 15 seconds, and the bypass delay is fixed at 0 seconds.
A manual reset is required after a delayed egress event.
Tone On Manual
1200DE Display Modes
SW9
Status Status
Door armed and locked
15.
Voice Off Manual
Alarm countdown has ended,
00. door is unlocked and alarm sounding
Tone On Manual
until reset.
Status SW9 Status
Door unlocked and alarm is shunted
UN
(REX or Bypass)
Voice Off Manual
Door has been opened after
OP
REX, Bypass or Alarm.
Tone On Manual
Test Procedure / Troubleshooting
NOTE: Ensure wires are not pinched when cover is installed.
Error Codes
Sensor Switch Error
E1
If E1 error occurs during initial install, adjust sex bolt and retry activation.
Ensure sex bolt is flush or slightly below flush to the surface of the strike.
E2 Door Position Sensor Error
Device not in energy savings mode.
15.
Please check Door Position Sensor
and Sensor Switch
Flashing Dot
NOTE: Fire Alarm input: If fire brake not used, install provided jumper on the terminal block
if a dry normally closed contact from a fire alarm input OR smoke detector system is not connected.
*May not be applicable to specific Chicago and California variants. Please consult local AHJ to ensure code requirements are met.
7 of 8