Preparing The Camera; Charging The Batteries; Installing The Batteries - Concord Camera 5040 User Manual

PREPARING THE CAMERA

PREPARING THE CAMERA

CHARGING THE BATTERIES

The supplied battery charger can charge up to two pieces of AAA and or AA size batteries.
1. Insert the supplied rechargeable batteries into the charger with its (+) and (-) ends
matching the polarity indication engraved inside the charger.
2. Plug the charger into a standard AC power outlet. The green indicators will light up.
3. It will take around 25 hours for the batteries to be fully charged. When the
batteries are fully charged, unplug the charger from AC outlet first, and then
remove the batteries.
Note:
1. If the green indicators did not light up, check if the batteries are loaded correctly.
2. It is normal for batteries to become ware while charging.
3. The green indicators will remain on when batteries are fully charged. Judge if the batteries are fully
charged by noting down the charging time.
4. To reduce the risk of injury, charge only Ni-MH / Ni-CD batteries with this charger. Other types of
batteries might burst, causing personal injury and damage.

INSTALLING THE BATTERIES

NOTE: The supplied rechargeable batteries are not charged when you receive them. Charge them before
loading them into the camera.
1. Slide the Battery/Memory Card door in the direction of the arrow,
and lift it open.
2. Insert two AAA batteries with the positive (+) and negative (-) poles
matching the directions indicated inside the battery cover.
3. Close the Battery/Memory Card door.
Battery Status Indications
The LCD monitor displays an icon to let you know battery status.
Battery Level
Indicator
When low battery icon is shown on the LCD, recharge the batteries or replace the batteries with new ones.
High Low
7