Table of Contents
Advertisement
APPENDIX
TROUBLESHOOTING
Problem
The camera cannot be turned on.
The camera cannot take pictures
The flash doesn't fire.
Image is blurry or out of focus
Image is not displayed on the
LCD monitor
Recorded images are not saved
in memory
Cannot transfer images to a
computer after connecting the
USB cable
Cause
Batteries are inserted in the
wrong direction
Battery is dead.
The battery compartment door
is open.
The flash is charging.
Memory is full.
Maximum file number is
exceeded.
Flash is set to OFF.
The camera was moving when
the image was captured
The subject was beyond the
range within which the camera
can focus
An SD Card with non-DCIF
images (recorded with another
camera) is loaded
The camera was turned off/
powered down before the image
was stored in memory
USB driver is not installed
38
Solution
Reload the batteries properly
(p.7).
Replace or recharge the batteries
Make sure the battery
compartment door is securely
closed.
Insert a new SD card.
Delete unwanted files or insert a
new SD card.
The card may be defective, use
a new card.
Set the flash to any mode except
OFF.
Hold the camera steady when
shooting picture.
1. Turn the Macro mode on if the
subject is within 20 cm.
2. Don't use Macro mode when
shooting distant subjects.
This camera cannot display non-
DCIF images.
If the Battery Low indicator
appears on the LCD monitor,
replace the battery immediately.
Install the USB driver before
you connect the camera to a
computer / turn the camera on.
APPENDIX
Advertisement
Table of Contents
