Safety - Vision 16 Series User Manual

Introduction 7
1.2

Safety

WARNING: Do not attempt to operate this equipment until you have read thoroughly and
understood completely the instructions contained in this User's Guide! Failure to comply may
result in damage to the equipment and/or inflict serious personal injury!
Only trained personnel should operate the Vision Engraver or Router. All individuals operating this
system should have read and understand this complete User's Guide.
Use of this equipment by unauthorized or untrained personnel may result in damage to the equipment
and/or inflict serious personal injuries.
Never use this machine in a hazardous environment. Do not store or use this machine outdoors. Do
not run this machine in an extremely hot environment.
Place the equipment in a location with low humidity and a minimum of dust. Avoid placing the
equipment in direct sunlight or in locations with excessive heat.
Do not expose the equipment to rain or use it near water. You can clean the controller with a damp
cloth, but be sure to unplug the unit first.
Follow the maintenance instructions for proper cleaning of the controller air filter.
There are no user serviceable parts inside the controller. Please contact qualified service personnel
for service issues.
Openings are provided in the controller box for ventilation. Do not cover the openings or place the
controller in an environment where the openings may become blocked.
Never insert anything into the ventilation openings. Doing so may create a danger of electric shock.
Always stop the machine before making any adjustments.
Keep hands clear of the bottom of the spindle during operation.
Do not operate the equipment with the covers removed.
Use extreme caution when inserting or removing cutters.
Before any servicing, disconnect the power cord.
© 2013 Vision Engraving & Routing Systems