Vision 16 Series User Manual page 25

What not to Lubricate
Many of the bearings and assemblies in your engraving machine are sealed and/or coated using
special low-friction methods and should not be lubricated. Do not not attempt to lubricate the spindle
bearings. If you suspect lubrication problems, call Vision for instructions, as further lubrication may
harm the machine. Do not not lubricate the X or Y stepper motors.
Maintenance Schedule
The following is a suggested maintenance schedule. Remember that in conditions of prolonged use,
unusual environments, or unusual applications, maintenance items may need to be performed more
frequently than suggested in this schedule.
Frequency
As Needed
Every Day
Every Week
Every Month
Every Year
© 2013 Vision Engraving & Routing Systems
Maintenance Items
Vacuum and/or brush debris
Clean Vacuum Canister Filters (if equipped with Vacuum Chip Removal
System)
Remove chips from the spindle area
Clean and Lubricate X and Z-Axis Linear Rails
Lubricate X, Y and Z-Axis Leadscrews
Lubricate the Spindle Housing
Lubricate Y-Axis Linear Rails
Maintenance 25