Octis™ Universal Lever Assembly Kits; Octis Universal Lever Assembly Instructions - CommScope ERA CAP L2 18/21/ 23T/26 F-DC Installation Manual

OCTIS™ Universal Lever Assembly Kits
OCTIS™ is a trademark of Radiall. The following connector drawings and instructions were provided by
Radiall.
Scan the QR code to the right to watch the OCTIS SFP+ connector assembly video.
All CAP L2s include two OCTIS Universal Connector Kits (CommScope PN 7847069) for the interface to the
Classic CAN or TEN that plugs into Port 1 and Port 2 on the CAP L2. CommScope provides the two OCTIS Kits
for each CAP L2.
OCTIS Kit Protective Kit
Figure 3 and Figure 4

OCTIS Universal Lever Assembly Instructions

Octis™ is a trademark of Radiall. The following connector drawings and instructions were provided by
Radiall.
The following instructions are for the OCTIS Universal Lever kit (CommScope PN: 7847069). For additional
information, please contact Radiall.
M0203A9B_uc
© September 2022 CommScope, Inc.
Table 9. CAP L2 OCTIS Kits
Kit Name
OCTIS Universal
Connector Kit
Fiber/Cable
Protective Kit
show the LC Duplex connector. The single fiber assembly instructions are the same.
CommScope PN Description
7847069 This is the connector that you use to seal the fiber cable port.
The OCTIS Universal Kit is provided with the CAP L2.
7823597 Use to protect fibers or cables; is 2m (78.7") long.
NOTE: An Optical or Ethernet OCTIS Kit is required and
must be ordered separately.
Fiber CAP L2 Overview
CommScope ERA ® CAP L2 with Fiber Interface
Page 13