Lexmark MS531 User Manual page 182

Notices
Notes on EPEAT-registered imaging equipment products:
•
Standby power level occurs in Hibernate or Off mode.
•
The product shall automatically power down to a standby power level of ≤ 1 W. The auto standby function
(Hibernate or Off) shall be enabled at product shipment.
Off mode
If this product has an off mode which still consumes a small amount of power, then to completely stop product
power consumption, disconnect the power supply cord from the electrical outlet.
Total energy usage
It is sometimes helpful to estimate the total product energy usage. Since power consumption claims are
provided in power units of Watts, the power consumption should be multiplied by the time the product spends
in each mode in order to calculate energy usage. The total product energy usage is the sum of each mode's
energy usage.
Applicability of Regulation (EU) 2019/2015 and (EU) 2019/2020
Per Commission Regulation (EU) 2019/2015 and (EU) 2019/2020, the light source contained within this product
or its component is intended to be used for Image Capture or Image Projection only, and is not intended for
use in other applications.
Thailand NBTC technical standards conformity statement
คํ า ประกาศเรื ่ อ งการเป็ นไปตามมาตรฐานทางเทคนิ ค ของ กสทช. ประเทศไทย
This telecommunication equipment conforms to the technical standards or requirements of NBTC.
เครื ่ อ งโทรคมนาคมและอุ ป กรณ น ี ้ ม ี ค วามสอดคล อ งตามมาตรฐานหรื อ ข อ กํ า หนดทางเทคนิ ค ของ กสทช.
Regulatory notices for wireless products
This section contains regulatory information that applies only to wireless models.
If in doubt as to whether your model is a wireless model, then see
Modular component notice
Wireless models contain the following modular component:
AzureWave AW-CM467-SUR; FCC ID:TLZ-CM467; IC:6100A-CM467
To determine which modular components are installed in your particular product, refer to the labeling on your
actual product.
"Wireless support" on page
182
46.