Operation; Australian/New Zealand Warranty; Using This Manual - Selectronic SP PRO Instruction Manual

OPERATION | Warranty and manual use

Australian/New Zealand Warranty

Your Selectronic SP PRO product is warranted by the manufacturer to the original purchaser only. The
manufacturer will bear the cost of parts and labour to repair any faults found within the terms and period of
this warranty. For full warranty terms and conditions please see the warranty card packed with your SP PRO
inverter.
If you have purchased your SP PRO outside Australia or New Zealand, please see the separate warranty
supplied by the authorised distributor in your country.
Maximum warranty duration is given when the SP PRO is installed by a Selectronic Accredited Integrator
and warranty registration is carried out on-line
Selectronic Australia shall have no obligation as to any equipment which has been improperly installed,
stored, or handled, or which has not been operated or maintained according to this manual, nor for any
operating mistakes and consequences arising from them.

Using This Manual

While every attempt has been made to ensure this manual is as self explanatory and clear as possible,
there are some technical issues and safety warnings that require thorough understanding. It is extremely
important that you and your integrator/installer follow all of the instructions set out in this document; failure to
do so may void your warranty and stop you from gaining the full benefits that this product can provide.
This manual is divided into four sections to allow fast access to relevant information. The heading on each
page indicates the section.

OPERATION

INSTALLER
SP LINK
SERVICE
A PDF copy of this manual may be downloaded from the Selectronic web site
is also included within the Help menu of the SP LINK software.
You will notice that throughout the manual these symbols will be repeated. These symbols are very
important.
This symbol indicates danger. Failure to observe this warning may result in serious injury or
death, loss of property or damage to the power system
This symbol is used to draw attention to information that will assist you in making full use of
your system or gives notice to information which may not seem immediately apparent
|
6
Doc #OI0003 Part #004122 Rev14 2013
Information relevant to the user and covers the day to day operation of the SP PRO as
well as certain safety warnings. This section presumes the unit's installation and set
up is complete and correct.
Contains information relevant to the installers from unpacking the unit to configuring
the settings of the SP PRO.
Describes the use of SP LINK software provided with your SP PRO. See the SP LINK
manual (contained in the SP LINK software) for Configuration Settings and Monitoring
details.
Provides information to service personnel in regards to preventative maintenance and
troubleshooting in case of a fault.
at.www.selectronic.com.au
www.selectronic.com.au and