Remote Release From A Receiver Unit - Canon 0585C006 Instruction Manual

Remote Release from a Receiver Unit

Modeling flash is not possible from a receiver unit with cameras released

up to 2011 or EOS REBEL T5/1200D.
For the precautions related to modeling flash, see page 36.

When C.Fn-02-1 is set on the sender unit, modeling flash will not be fired

even if you select <M>.
When there are two or more sender units (p.58), the flash signal is sent to
the main sender that has the <D> lamp lit in green.
Remote Release from a Receiver Unit
When using an EOS DIGITAL camera released in and after 2012, such
as EOS-1D X, you can perform remote release (remote control
shooting) from a 430EX III-RT set as a receiver unit during radio
transmission wireless shooting.
Remote release is not possible from a receiver unit with cameras

released up to 2011 or EOS REBEL T5/1200D.
Shooting is not possible when autofocus fails. It is recommended that

you set the focus mode switch of the lens to <MF>, manually focus on
the subject, then release.
Remote release is performed with "Single shooting" regardless of the

camera's drive mode setting.
When there are two or more sender units (p.58), the release signal is

sent to the main sender that has the <D> lamp lit in green.
66
Select <L>.
Press <8> of the receiver unit.

Turn <9> to select <L>, then

press <8>.

A release signal is sent from the
receiver unit to the sender unit, and
the picture is taken.