Q: Wireless Multiple Flash Shooting With Manual Output - Canon 0585C006 Instruction Manual

q: Wireless Multiple Flash Shooting with Manual Output

This section describes wireless (multiple flash) shooting using manual
flash. You can shoot with a different flash output setting for each
receiver unit (firing group). Configure all the settings on the sender unit.
Firing group control
When <8> is set, set A, B, or C as the firing group for the receiver units
(p.59). The flash will not fire if it is set to D or E.
62
Set the flash mode to <q>.
1
Press the <

<S> cross keys of the sender unit.
Turn <9> to select <R>, then

press <8>.
Set firing group control.
2
Press <8>.

Turn <9> to select the firing group

control symbol, then press <8>.
Turn <9> to select the group to be

fired, then press <8>.
<T> : Set all groups to the same
<U> : Set the flash output of A
<V> : Set the flash output of A, B,
Set the flash output.
3
Turn <9> to select the firing group

symbol, then press <8>.
Turn <9> to set the flash output,

then press <8>.
With <5> and <7>, repeat

steps 3 to set the flash output for all
groups.
Take the picture.
4

Each group fires at the set flash ratio.
E > button of the
flash output
and B
and C