Canon 0585C006 Instruction Manual page 84

C: Setting Custom Functions
C.Fn-08:
0: ON (Enabled)
1: OFF (Disabled)
This disables the emission of the AF-assist beam from the Speedlite.
The flash symbol displayed with C.Fn-08 set changes according to the
setting of P.Fn-05 (p.87).
C.Fn-10:
You can change the time for the receiver unit's auto power off to take effect.
Note that when the receiver unit's auto power off takes effect, </> is
displayed on the LCD panel. Set this function on each receiver unit.
0: 60min (60 minutes)
1: 10min (10 minutes)
C.Fn-11:
When you press the test flash button of sender unit, you can turn on the
receiver units in the auto power off status. You can change the time for the
receiver units in auto power off status to accept this function. Set this
function on each receiver unit.
0: 8h (Within 8 hours)
1: 1h (Within 1 hour)
C.Fn-13:
0: (Speedlite button and dial)
4
1: (Speedlite dial only)
5
You can directly set the flash exposure compensation amount and
flash output by turning <9> without pressing the <O> button of the
<S> cross keys.
84
I
(AF-Assist beam firing)
/
(Receiver auto power off timer)
0
(Receiver auto power off cancel)
6
(Flash exposure compensation setting)