Installing The Batteries - Canon 0585C006 Instruction Manual

Installing the Batteries

Install four AA/R6 batteries for power supply.
Firing Interval and Number of Flashes
Quick Flash
Approx. 0.1 to 2.5 sec. Approx. 0.1 to 3.5 sec.
Based on new AA/LR6 alkaline batteries and Canon's testing standards.

The Quick flash function enables flash shooting before the flash is fully

charged (p.18).
CAUTION
Do not use AA/R6 lithium batteries.

Note that certain AA/R6 lithium batteries may become extremely hot in rare
cases during usage. Due to safety reasons, do not use "AA/R6 lithium batteries".
When continually firing, do not touch the flash head, batteries, or the

area near the battery compartment.
When continuous flash or modeling flash is repeatedly fired with short
intervals, do not touch the flash head, battery, or the area near the battery
compartment. The flash head, batteries, and area near the battery
compartment become hot, resulting in the risk of burn.
Do not use the Speedlite while touching the same part for a long period of time.

Even if the product does not feel too hot, prolonged contact with the same
body part may cause skin redness, blistering or low-temperature contact
burns. Using a tripod is recommended for people with circulation problems
or very sensitive skin, or when using the product in very hot places.
16
1
2
3
Firing Interval
Normal Flash
Open the cover.
Slide the battery compartment cover

down, then open the battery
compartment cover.
Install the batteries.
Make sure the "+" and "-" battery

contacts are correctly oriented as
shown in the battery compartment.
Close the cover.
Close the battery compartment cover

and slide it up by following the
procedure of step 1 in reverse.
Approx. 180 to 1200 times
Number of Flashes