Canon 0585C006 Instruction Manual page 69

When you want to clear linked shooting, operate the Speedlites one by

one to change the setting to <P> in step 1.
You can use this function as a remote control for linked shooting without

attaching a Speedlite to a camera. Press <8> of the sender unit and
select <L> to release all receiver camera units.
During linked shooting, the time until auto power off takes effect is

approx. 5 min. for both the sender and the receiver units. Note that when
the interval of linked shooting is 5 min. or longer, set the "Auto power off"
to "OFF" on both the sender and the receiver units (C.Fn-01-1, p.83).
Linked Shooting with Radio Transmission
When changing the setting from

"receiver unit" to "sender unit" in step
2, other Speedlites (or transmitters)
that were set as "sender unit" until
then automatically switch to "receiver
unit".
Set up the receiver camera units.
6
Set up all the receiver camera units

within approximately 30 m/98.4 ft. of
the sender camera unit.
Check that the <D> lamps of the

receiver units are lit in green.
Take the picture.
7
Check that the <D> lamp of the

sender unit is lit in green and take the
picture.

The receiver camera units are
released linked with release of the
sender camera unit.
 After shooting with linked shooting,
the <D> lamps of the receiver
units are briefly lit in orange.
69