Step 3: Mount The Router - Cradlepoint R2100 Series Quick Start Manual

5g ruggedized router
Table of Contents

Advertisement

 
STEP 2: Install SIM (if not pre-installed)
1. Loosen the two Torx security screws until the captive screws and SIM door can be removed.
2. Install at least one SIM card, with contacts up and notch facing toward the router.
3. Replace door and secure the Torx screws.
 

STEP 3: Mount the router

The router must be mounted on a relatively flat exterior vehicle surface. Very mildly curved surfaces can be
accomodated, if the curve allows the entire adhesive surface of the router to engage, and produces no gaps between
the gasket and mount surface.
1. Place the mounting template on the chosen spot on the exterior of the vehicle.
2. Align mounting template in desired location on vehicle making sure device footprint and hole placement are in
desired locations with no obstructions (above or below).
3. Tape or otherwise temporarily secure the mounting template to the roof panel.
4. Drill the cable routing hole using a "hole saw" bit, 22mm or 15/16" diameter hole saw sizes are recommended.
When finished, remove the mounting template.
5. Remove both pieces of the adhesive protective liner from the contact surface of the router, and from the two
thermal pads.

Advertisement

Table of Contents
loading

This manual is also suitable for:

R2105R2155S5a237a

Table of Contents