Table of Contents
Advertisement
PLUG
The plug cord is 9 ft long and is located on the right hand rear of the
merchandiser. Disconnect power before servicing. VRM merchandisers
require a dedicated electrical circuit with ground. 12AWG is the
minimum sized acceptable wire.
• The VRM models require a dedicated 15 AMP/115V circuit
with a grounded wall receptacle (NEMA 5-15P).
• Always use a dedicated circuit with the amperage stated
on the unit.
• Plug into an outlet designed for the plug.
• Do not overload the circuit.
• Do not use long or thin extension cords. Never use
adapters.
• If in doubt, call an electrician.
FIELD WIRING
Field wiring must be sized for component amperes stamped on the
serial plate. Actual ampere draw may be less than specified.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3034041_ J
ELECTRICAL / REFRIGERATION
Providing Information About Safety Messages in Collateral Ma
A1
Explanation of Signal Words and Symbols
Signal words and safety symbols that are used in a product's collateral materials
be defined in collateral materials if space is available.
A1.1
Safety Alert Symbol
The meaning of the safety alert symbol may be provided in collateral materials. T
be used for this purpose.
6
VRL-1
Nominal
Voltage
A1.2
Signal Words
The meaning of the different signal words as defined by the ANSI Z535.6 and AN
120
may be explained in collateral materials. The following artwork may be used for
» If the supply cord is damaged, it must be replaced by
the manufacturer, its service agents or similarly qualified
persons in order to avoid hazard.
» Merchandiser must be grounded.
» Do not remove the power supply cord ground.
A1.3
Other Highlighting Conventions
The meaning of any other highlighting conventions used to differentiate safety m
manipulations, indention, etc.) may be explained in collateral materials.
A1.4
Safety Symbols
The meaning of any safety symbols used on safety labels or collateral materials
collateral materials.
Copyright National Electrical Manufacturers Association
Provided by IHS Markit under license with NEMA
2-1
No reproduction or networking permitted without license from IHS
Annex A
Safety Signs and Labels
(Informative)
P
5-
P
This is the safety alert symbol. It is us
All Models
to potential physical injury hazards. O
VRL-2
VRMB
messages that follow this symbol to
injury or death.
Minimum
Maximum
Voltage
Voltage
108
132
P
DANGER indicates a hazardous situa
avoided, will result in death or se
WARNING indicates a hazardous situ
avoided, could result in death or
CAUTION indicates a hazardous situ
avoided, could result in minor or
NOTICE is used to address practices
physical injury.
Safety instructions (or equivalent) sig
safety-related instructions or proc
© 2017 National Electrical Manufacturers Association
Licensee=Hussmann Corp/8160899001, User=Trevet
Not for Resale, 02/16/2021 11:49:55 MST
5-15P
Advertisement
Table of Contents
