Table of Contents
Advertisement
Hussmann Self-Contained Refrigeration Equipment Start Up Check List
SELF-CONTAINED REFRIGERATION EQUIPMENT
***Please note that failure to follow this start-up document may void your factory warranty***
START-UP CHECKLIST
Step
Locate, read and maintain install/operation manual in a safe place for
1
future reference.
2
Examine unit. Confirm there is NO damage or concealed damage.
3
Level the unit, side to side and front to rear.
4
Remove all shipping brackets/compressor straps/bolts etc.
Unit must be run on a dedicated electrical circuit without the use of
5
an extension cord.
Ensure that the proper electrical requirements for the equipment are
6
supplied.
7
Verify field electrical connections are tight.
Verify all electrical wiring is secured and clear of any sharp edges or
8
hot lines.
9
Verify the condensate drain line is properly trapped and pitched.
10
Verify all required clearances on the sides and back of unit.
Verify there are no air disturbances external to the unit. Heat and air
11
registers, fans, and doors etc.
Advise owner/operator that merchandiser must operate at temperature for 24 hrs prior to loading
Form HSCW01 Rev. 30MAY12 P/N 0525209_B
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3034041_ J
LEGAL DISCLAIMER:
Hussmann shall not be liable for any repair or replacements made without the written consent of Hussmann, or when the product is installed or operated in a manner
Startup Activity
with product.
LEGAL DISCLAIMER
Hussmann shall not be liable for any repair of
replacement made without the written consent
of Hussmann, or when the product is installed
or operated in a manner contrary to the printed
Check
instructions covering installation and service
which accompanied such product.
Please note that failure to follow this start up
document may void your factory warranty.
» To avoid serious injury or death from electrical
1-8
A1
Explanation of Signal Words and Symbols
Signal words and safety symbols that are used in a product's collate
be defined in collateral materials if space is available.
A1.1
Safety Alert Symbol
The meaning of the safety alert symbol may be provided in collateral
be used for this purpose.
This is the safety alert symbo
to potential physical injury h
messages that follow this sy
injury or death.
A1.2
Signal Words
The meaning of the different signal words as defined by the ANSI Z5
may be explained in collateral materials. The following artwork may b
— LOCK OUT / TAG OUT —
shock, always disconnect the electrical power at
the main disconnect when servicing or replacing
any electrical component. This includes, but is not
limited to, such items as doors, lights, fans, heaters,
and thermostats.
A1.3
Other Highlighting Conventions
The meaning of any other highlighting conventions used to differentia
manipulations, indention, etc.) may be explained in collateral materia
A1.4
Safety Symbols
The meaning of any safety symbols used on safety labels or collater
collateral materials.
© 2017 National Electrical Manufacturers
Copyright National Electrical Manufacturers Association
Provided by IHS Markit under license with NEMA
No reproduction or networking permitted without license from IHS
DANGER indicates a haz
avoided, will result in
WARNING indicates a ha
avoided, could result
CAUTION indicates a haz
avoided, could result
NOTICE is used to addre
physical injury.
Safety instructions (or equ
safety-related instruc
Licensee=Hussmann Corp/816
Not for Resale, 02/16/2021 11
Advertisement
Table of Contents
