Table of Contents
Advertisement
2
Battery lock tab
1
NVMEM battery pack
2
Step 3.
Grasp the battery and press the blue locking tab marked PUSH, and then lift the battery out of the
holder and controller module.
Step 4.
Remove the replacement battery from its package.
Step 5.
Align the tab or tabs on the battery holder with the notches in the controller module side, and then
gently push down on the battery housing until the battery housing clicks into place.
Step 6.
Close the CPU air duct.Make sure that the plug locks down to the socket.
Reinstalling the controller
After you replace a component within the controller module, you must reinstall the controller module in the
system chassis and boot it to a state where you can run diagnostic tests on the replaced component.
About this task
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-CZwRXsocAOmi5RsaXDVZQG
Step 1.
If you are not already grounded, properly ground yourself.
ThinkSystem DM7000x Hardware Installation and Maintenance Guide
26
1
Advertisement
Table of Contents
