Table of Contents
Advertisement
Step 1.
If you are not already grounded, properly ground yourself.
Step 2.
Loosen the hook and loop strap binding the cables to the cable management device, and then
unplug the system cables and SFPs (if needed) from the controller module, keeping track of where
the cables were connected. Leave the cables in the cable management device so that when you
reinstall the cable management device, the cables are organized.
Step 3.
Remove and set aside the cable management devices from the left and right sides of the controller
module.
Step 4.
Loosen the thumbscrew on the cam handle on the controller module.
2
Thumbscrew
1
Cam handle
2
Step 5.
Pull the cam handle downward and begin to slide the controller module out of the chassis. Make
sure that you support the bottom of the controller module as you slide it out of the chassis.
Replacing the boot media
You must locate the boot media in the controller and follow the directions to replace it.
About this task
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-CZwRXsocAOmi5RsaXDVZQG
Step 1.
If you are not already grounded, properly ground yourself.
Step 2.
Locate the boot media using the following illustration or the FRU map on the controller module:
ThinkSystem DM7000x Hardware Installation and Maintenance Guide
68
LNK
1
Advertisement
Table of Contents
