Braking System - Technogym Skillmill Assembly Manual

5. Remove the guard located under the side covering.
6. Remove the front guard.
7. Remove the right-hand front side guard.
8. Disconnect the brake cable.
9. Remove the upright.
7.7

BRAKING SYSTEM

7.7.1 DISASSEMBLING THE BRAKE LEVER ASSEMBLY
1. Remove the circular guard from the brake lever assembly.
2. Remove the guard located under the circular guard of the brake lever assembly.
3. Remove the brake lever.
4. Remove the guard.
5. Remove the brake lever assembly components and take the brake cable out of its seat.
7.7.2 DISASSEMBLING THE BRAKE CABLE
1. Disassemble the braking system as explained in paragraph
lever assembly".
Before replacing the brake cable: make sure the stop screw is adjusted correctly and that its position
does not change when the cable is replaced. To be safe, mark the position of the stop screw as a
reference. The stop screw is positioned correctly if the screw touches the frame slightly when
the lever is pulled back completely. This means that the screw is resting up against the
frame, with less than one 180° degree turn to fully tighten it.
Before replacing the brake cable, check and mark the cable path. Take the two references as shown
below.
Page 100
Technical Service Guide - Rev. 3.5
"7.7.1 disassembling the brake
email: support@technogym.com
Skillmill