SCS.3d Rear Panel
4.3
SCS.3d Rear Panel
The SCS.3d has a single USB type B connector. (Figure 4.16)
USB TYPE B
Figure 4.16
Use the included USB cable to connect this to one of the type A connectors on the SCS.3m. You can
either choose to use the wire management guides to bring the cable out of the side of the SCS.3d
and into one of the internal ports on the SCS.3m, or you can come out of the top of the SCS.3d and
connect to one of the exterior ports on the SCS.3m. Going through the side of the controllers results
in a cleaner look, but it's harder to separate the units. Going through the top does not look as neat,
but allows you to quickly pull all the controllers apart.
22