Set-Up Files; Text File - Renesas DA7210 Manual

DA7210/11 USER MANUAL
Select Finish
If you are using Windows XP, you may get a message saying that a USB2 device is attached to a
USB1.1 port. This can safely be ignored.
To uninstall the software please use the Windows 'Add/Remove Programs' function that can be found
under 'Start->Settings->Control Panel'.

4.2 Set-up Files

4.2.1

Text File

The DUT registers can written to by submitting a text file containing the register values; Figure 10
shows an example file. Only the data in the first three columns is required: register, data, R/W; other
comments, such as those shown in the example, will be ignored. Lines of text that do not follow
register write entries should be preceded by // in order that the line is ignored when reading the text
file.
The text file can be created by saving the first three columns of the template spreadsheet file above
as a text file or can be created from scratch; it is only necessary for the text file to contain the
registers required for set up all others can be omitted.
To add a delay in the file the register value is entered as Delay followed by the delay time require in
milliseconds. The example in Figure 10 shows a 100ms delay added as the third entry.
DA7210/11 User Manual Rev 2.9 - January 2022
16
© 2022 Renesas Electronics