Advertisement
Step 3. Install your front wheel.
E.
Identify the disc brake rotor side of the front wheel. Orient the wheel
so the rotor is on the left side – the same side as the front brake pads.
Gently lift the front of the bike and roll the front wheel back into the
fork.
F.
Carefully guide the right-side fork dropout onto the groove in the
speed-release thru-axle.
G.
Use a hex wrench to firmly tighten the speed-release thru-axle. When
properly tightened, the wrench should leave a mark on your hand.
H.
At this point you can remove any additional packaging from the bike.
SET-UP
STEP 1
STEP 2
STEP 3
E
F
G
H
STEP 4
PRE-RIDE CHECK
Advertisement
