Advertisement
Some final pre-ride checks.
I
I.
Secure the front wheel between your legs and turn the handlebar.
If the handlebar and wheel move independently, the stem bolts are
not tight enough. Use the torque wrench and correct bit to properly
torque the bolts.
J.
Brake Check. Confirm the front and rear brakes engage when the
J
levers are squeezed. The brake lever and handlebar should not come
into contact with the brakes fully engaged.
K.
Tire Pressure. Inflate the tires to the manufacturer's recommended
tire pressure, which is marked on the tire sidewall.
L.
Wheel Engagement. Verify both speed-release thru-axles are
tightened securely. The wrench should leave a mark in your hand.
K
L
SET-UP
STEP 1
STEP 2
STEP 3
STEP 4
PRE-RIDE CHECK
Advertisement
