Advertisement
Some final pre-ride checks.
E.
Tighten the seatpost collar to the torque value indicated on the collar
– typically 7 Nm.
F.
Reflectors. Make sure your reflectors are tight and in the correct
position. Your front reflector should point straight ahead, perpendicular
to the ground. The rear reflector should point straight back. Gently
pull the wheel reflectors toward the rim to ensure they are snug.
G.
Twist Checks. 4. Grab the front and back of the saddle and attempt
to tilt it on the seatpost head. It should not move.
H.
Attempt to rotate the handlebar forward and backward in the stem. If
it moves, the stem faceplate bolts are not tight enough. Use the torque
wrench and correct bit to torque the faceplate bolts to specification,
using the same "X" pattern as before.
SET-UP
STEP 1
STEP 2
STEP 3
E
F
G
H
STEP 4
PRE-RIDE CHECK
Advertisement
