Related Manuals for Cannondale Topstone Neo Carbon
Summary of Contents for Cannondale Topstone Neo Carbon
- Page 1 English Topstone Neo Carbon Owner’s Manual Supplement READ THIS SUPPLEMENT AND YOUR CANNONDALE BICYCLE OWNER’S MANUAL. Both contain important safety information. Keep both for future reference.
-
Page 2: Table Of Contents
Indicates a hazardous situation which, if not avoided, may result in death or serious E-Bike Maintenance ....34-36 Please contact your Authorized Cannondale injury. Dealer immediately if you need a manual or supplement, or have a question about your NOTICE bike. -
Page 3: Identification
________________________________________ that owners always have mechanical assistance mode/level you set with the To register your bike: go to the work done by an Authorized Cannondale handlebar control unit. At anytime, if you Product Registration section of our Dealer. stop pedaling, the drive-assist will dis- website at www.cannondale.com... - Page 4 Follow any state or local laws for any minimum age restrictions for E-Bikes. We urge you to read PART II, Section D. • Creaking or other unexplained Ask your local Authorized Cannondale Dealer for more information about operating an “Inspect For Safety” in your Cannondale noises, electrically assisted pedal bicycle in your area.
- Page 5 Safety Information Safety Information Operation Operation Topstone Neo Carbon OMS Operation continued from previous page... Always wear an approved bicycle helmet and all other protective gear (e.g. gloves, pads, and cycling shoes). Wired system control: If the drive system control device is detached from the mount or the cables are disconnected to damaged, the drive system will automatically shut off.
- Page 6 Take to a waste facility/recycler. rider. Use only specified Cannondale and/ FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN ELECTRICAL FIRES, or manufacturer drive-assist service and EXPLOSION, OR SEVERE BURNS OR ELECTROCUTION.
-
Page 7: Key
Spare Key The drive system may be activated by this You can be severely injured, paralyzed or threaded insert, please ask your Cannondale same key. Please consult the drive system killed in an accident if you ignore this Dealer for help. -
Page 8: Technical Information
Technical Information Technical Information Specifications Geometry Topstone Neo Carbon OMS TECHNICAL INFORMATION Geometry Specifications Item Specification Drive System Bosch Performance Line CX Battery Bosch PowerTube 500Wh Drive-Assist Owner’s Manual https://www.bosch-ebike.com/ 75 mm Head Tube UPR: 1-1/8in LWR: 1-1/2in Headset Integrated, 1-1/8in-1-1/2in... - Page 9 Stack 54.9 57.5 61.0 64.0 the level of disassembly required to gain access, have any repairs or replacements of the battery, cables or hoses parts identified performed by an authorized Cannondale e-bike service center. Reach 37.7 38.7 39.4 40.2 138222 Rev 1 (03/20)
- Page 10 (4). If damage is found; do not ride the bike. Have any damaged part replaced with Do not tamper/ a new one. Contact your Cannondale battery-to-cover Dealer. attachment only 138222 Rev 1 (03/20)
- Page 11 Technical Information Technical Information Battery Charging Port Front Derailleur Mount Topstone Neo Carbon OMS Battery Charging Port Front Derailleur Mount Rear Derailleur Mount The battery charging port is located on the left side of the bicycle at the headtube. The charging port enables the battery to be charged while installed in the bicycle.
- Page 12 Technical Information Technical Information Rear Fender Support Chain Guide Topstone Neo Carbon OMS Rear Fender Support Identification Curve washer Identification Maintain tire clearance with fender. M5 Bolt 1. Fender Support Shroud 2. Screw (2X) FD Mount Bolt Spring 4 N·m...
- Page 13 Technical Information Technical Information LockR Pivot LockR Pivot Topstone Neo Carbon OMS LockR Pivot • Do not install assembled. • Apply grease to all parts. To remove the LockR from the frame: Loosen the screw 4-6 turns using a T25 Torx key.
- Page 14 Technical Information Technical Information Seat Tube / Seat Stay Pivot Bearings Seat Tube / Seat Stay Pivot Bearings Topstone Neo Carbon OMS Seat Tube / Seat Stay Pivot Bearings REMOVE 5. Pull SS end away from ST just enough to...
- Page 15 To adjust: A seat post should not be bottomed out inside the Insert the prepared seat post into the frame. frame at any time. Have your Cannondale Dealer size Maintain the specified minimum insert. the seat post appropriately. Set the saddle height.
- Page 16 Service Instruction for the parts kit. These instructions are not provided in this manual. We reccommend that you have a Cannondale Dealer perform the replacement. Please Note: During first assembly of the nut base, it is important to not push on the 4mm allen The pressure sensitive adhesive when tightening onto the seatpost.
-
Page 17: Replacement Parts
Replacement Parts Replacement Parts Frame Battery / Motor Covers Topstone Neo Carbon OMS REPLACEMENT PARTS 1 N·m 2 N·m 8 N·m 1 N·m 2 N·m 8 N·m eTap 2 N·m Bosch Motor Covers eTap Heat Shield 2 N·m Bosch Motor Covers water bottle bolts 1-2 N·m... -
Page 18: E-Bike Maintenance
• Clean and visually inspect the entire bike for cracks or damage. See “Inspect for Drive-assist system components must Safety” in your Cannondale Bicycle Owner’s Manual.” Consult with your Authorized Cannonda- only be serviced at an authorized service le Dealer to create a complete main- •... - Page 19 E-Bike Maintenance Maintaining Your Bike Topstone Neo Carbon OMS Cleaning When cleaning your bike, use a damp sponge or a soft brush with only a mild soap and water solution. Rinse the sponge often. Do not spray water directly on controls or drive system components.
- Page 20 © 2020 Cycling Sports Group Topstone Neo Carbon Owner’s Manual Supplement 138222 Rev. 1 CANNONDALE USA Cannondale Europe Cannondale UK Cycling Sports Group, Inc. Mail: Postbus 5100 Cycling Sports Group 1 Cannondale Way, Visits: Hanzepoort 27 Vantage Way, The Fulcrum,...
Need help?
Do you have a question about the Topstone Neo Carbon and is the answer not in the manual?
Questions and answers