Interface Specification - Renishaw Primo System Installation Manual

Interface specification

Principal application
Dimensions
Weight (with 8 m (26.2 ft) cable)
Transmission type
Radio frequency
Operating range
Compatible probes
Supply voltage
Supply current
Output signal
Input/output specification
Diagnostic LEDs
Cable
Mounting
Conduit
Environment
4-6 Primo™ system: Dimensions and specifications
Used to communicate signals between the part setter or tool setter and the
CNC machining centre .
Height
Width
Depth
950 g (33 .51 oz)
Frequency-hopping spread spectrum (FHSS) radio
2400 MHz to 2483 .5 MHz
Up to 10 m (32 .8 ft)
Primo™ radio part setter, Primo™ radio 3D tool setter and LTS
12 Vdc to 30 Vdc
100 mA at 24 V peak, 30 mA typical
Four machine outputs, comprising four solid-state relays (SSR) configurable
normally open or normally closed to be used for probe status 1, 2, error and low
battery / low credit; all of which can be inverted .
SSR output is protected by a circuit which limits the current to 100 mA. M‑code
input: up to 30 V (10 mA at 24 V maximum) for part setter and tool setter . Power
supply should be fused separately within the machine cabinet .
Digital 'credit days remaining' and error codes display, part setter, start, low
credit / low battery, probe status, error, signal, tool setter / length tool setter .
Specification
Length
Directional mounting with optional mounting bracket or flush mounting (both
available separately) .
A flexible conduit to aid protection of the interface cable can be purchased as
an optional extra . See page 5.14, "Interface cable", for further information .
IP rating
Storage temperature
Operating temperature
103 mm (4 .05 in)
84 mm (3 .31 in)
40 mm (1 .57 in)
Ø7 .5 mm (0 .29 in), 15-core screened cable, each
core 18 × 0.1 mm
8 m (26 .2 ft)
IPX8, BS EN 60529:1992+A2:2013
−25 °C to +70 °C (−13 °F to +158 °F)
+5 °C to +55 °C (+41 °F to +131 °F)