Table of Contents
Advertisement
9.6. Rear shock settings
5
Zero pressure in negative volume chamber
This is the most firm setting (race setting).
„
With the shock pressurized to ride setting, press the negative pressure
release button (5) to release any air in the negative spring volume
chamber.
Check your air pressure to make sure it hasn't changed. You should
„
have 0 mm of shock sag which can be fine-tuned by adding/removing
pressure.
27
5
Mid pressure in negative volume chamber
Introduces a small amount of sag for a less rigid ride.
„
Release all of the air from the shock.
„
Compress the shock to the midpoint marking (A).
While holding the shock at the midpoint, press the negative pressure
„
release button (5) for a few seconds.
„
Pressurize the shock to ride pressure. You should have 2-3 mm of
shock sag (shaded blue) which can be fine-tuned by adding/removing
pressure.
A
Advertisement
Table of Contents
